Ad Code

Responsive Advertisement

Make Your Graco Spray Gun Last Forever With These Tips



Different jobs require different mixing chambers as well as shifting pressures from your machine. Your gun requires care and maintenance in order to extend the life of the gun. Here, we discuss the top six gun enhancements you should have on hand in order to enhance and extend the life of your spray gun.


1.) Variable Flow Cap  The Variable Flow Cap is unique to Graco Fusion guns.

Variable Flow Cap for Graco Fusion 

This allows you to adjust the spray gun's output without having to modify the mixing chamber. This device conserves you time the difficulty of taking apart your Variable Flow Cap gun for different areas of the substrate that require different thicknesses.|This saves time and eliminates the need to disassemble your Variable Fluid Cap gun in order to adjust the output for different substrate areas that have different thicknesses.

Spray professionals tend to prefer a lower setting and can quickly toggle between full flow or reduced flow. There are 10 flow settings available on the cap, which can be set to full or limited output.

Spraying around doors, windows, corners and other areas that require less spray to reduce excess can be an example of a situation where regulated flow might prove advantageous.


2.) Overspray Release  Lubricating gun parts is a necessary step in everyday maintenance. Not only does using Overspray Release as a lubricant increase the life of your parts, which can be costly to replace, but it keeps your chemical material running smooth.


3.) Keep Material Warm and Screens Clean  For most people, this is an obvious step. It's easy to forget that even a slight change in the material temperature or a day or so of cleaning screens will make a big difference. It does, we are sure of it! Keep your material at the right temperature and heat, according to the manufacturer. Clean your screens after every use. 

4.) Polish Side Seal and Mixing Chamber  Your gun's life expectancy will be increased by polishing the side seal and mixing chamber. Sandpaper can be used to remove any particles. The motion also helps prevent uneven sanding. 





5.) Fix-It Box  

It is essential to keep a small inventory of commonly used parts in order to maintain your workflow. The Fix-It Box is available for AP2, AP3, APEX, and Fusion. It includes the most commonly needed o-rings that need to be replaced. There's nothing worse than having your gun stolen during a job, and then having to send a worker to pick up emergency parts. ArmorThane gives these to all new applicators in order to provide them with the necessary tools and easy fixes at any time.



6.) 
Power Flush System with Dynalube  
Cleaning your gun at the end each day is just like lubricating. This prevents any material from getting into the gun, which could lead to permanent damage.
Regular maintenance can prevent most of the repairs and service calls. The Power Flush System with Dynalube allows you to easily and properly clean your gun.|You can clean your gun with the Power Flush System and Dynalube.} Here's a video on how to use the Power Flush System.|This video shows you how to use the Power Flush System.

Post a Comment

0 Comments

Ad Code

Responsive Advertisement